In the last period, 4200CNE was packaged and delivered, and all the friends were very interested. This phase takes you into the production line, erecting machines, polishing and painting, installing adsorption cylinders, refrigerating and distributing power... The production process of SAIFUAIR 420 cubic zero-consumption compression heat suction dryer is greatly exposed!

Production process of 4200CNE compression hot suction dryer

With the continuous development of petrochemical industry, the demand for large compressors and drying equipment is also increasing. The SFA-4200CNE compression heat dryer imported by Hengli Petrochemical adopts high-end energy-saving devices, and uses waste heat for effective energy conversion in the process of heating regeneration and cooling, so as to achieve the purpose of two-way energy saving in heating and cooling.

Production process of 4200CNE compression hot suction dryer

Compression heat regeneration dryer regenerates desiccant by using the waste heat generated in the compression process of compressor. Compressed air is not consumed in the heating regeneration process, and the energy consumption of the whole adsorption and regeneration process is close to zero. At the same time, the high temperature heat of compressed air is fully utilized to directly enter the regeneration adsorption layer, and its high temperature heat is absorbed by adsorbent, thus reducing the heat load of the rear cooler. Therefore, the cooling water consumption is correspondingly reduced, and the compression heat of Tremella fuciformis has the characteristics of energy saving, which can realize effective energy saving to a greater extent.

Production process of 4200CNE compression hot suction dryer